sequential motor operations via RS-485

Discuss Stepper motors, Drivers, Controllers, GUI's and related Accessories here.
alands
Posts: 10
Joined: Sat Sep 10, 2016 9:09 pm

sequential motor operations via RS-485

Postby alands » Wed Jun 07, 2017 9:02 am

Is it possible to configure sequential motor operations using direct data operation commands, via RS-485, on an AZD controller? I haven't seen a method in the documentation.

Thank you

om_tech_support_JS
Posts: 110
Joined: Tue May 10, 2016 4:48 pm

Re: sequential motor operations via RS-485

Postby om_tech_support_JS » Thu Jun 08, 2017 2:36 pm

Hi alands,

Is your question in regards to a previous post that you had?
viewtopic.php?f=3&t=6018&p=10273#p10273


Using direct data operation commands does not allow for sequential motor operations.

alands
Posts: 10
Joined: Sat Sep 10, 2016 9:09 pm

Re: sequential motor operations via RS-485

Postby alands » Tue Jun 13, 2017 4:29 pm

Yes, I'm working on a way of compensating for the lower limits of the system's performance. For now I have a solution that appears functional, if inelegant.


Return to “Stepper Motors and Controls”

Who is online

Users browsing this forum: No registered users and 2 guests