Page 1 of 1

function of M0 M1 M2 in RKSD503-CD

Posted: Mon Aug 21, 2017 8:12 pm
by RISKIFITRAYADI
HELLO,

i want asking about driver stepper type RKSD503-CD, what is function M0 M1 and M2 in control input?

thanks

riski

Re: function of M0 M1 M2 in RKSD503-CD

Posted: Tue Aug 22, 2017 12:45 pm
by om_tech_support_JS
Hi Riski,

In regards to your post, the RKSD503-CD driver is a built-in controller (Stored Data) type driver. Therefore, you can store up to 64 different data points to this driver which you can then operate via the I/O. The M0 to M5 inputs can be used in a binary configuration in order to select the operation data number. Once the operation data number is selected, then the START input can be triggered and the operation can be run. Below is a reference to the binary configuration table for the M0 to M5 inputs. This table can be found on page 49 of the manual:
http://www.orientalmotor.com/products/p ... 085-4E.pdf

M0 to M5 inputs.png
M0 to M5 inputs.png (382.8 KiB) Viewed 259 times

Re: function of M0 M1 M2 in RKSD503-CD

Posted: Wed Aug 23, 2017 1:49 am
by RISKIFITRAYADI
Ok thank you for the information