Right Angle Hollow Shaft Gearhead Orientation

Discuss AC Induction motors, Reversible motors, Synchronous motors, Low-Speed Synchronous motors, Torque motors, Gearheads, Brake Packs and related Accessories here.
dlobacz
Posts: 1
Joined: Thu Aug 18, 2011 7:19 am

Right Angle Hollow Shaft Gearhead Orientation

Postby dlobacz » Thu Aug 18, 2011 7:36 am

I am looking at using a 41K25GN motor/gearhead with the shaft in a vertical orientation. Is this a problem? I know that oil filled gearboxes need to be specified to be used like this so that the oil does not leak, but I do not see anything in your literature that warns against using it in this manner. The load is very light, less than 3 pounds, so I am not too worried about thrust loading the bearings.

User avatar
omsupport1
Posts: 99
Joined: Thu Nov 19, 2009 10:34 am

Re: Right Angle Hollow Shaft Gearhead Orientation

Postby omsupport1 » Fri Aug 19, 2011 2:47 pm

There are no mounting orientation requirements for our gearheads.

Good luck!
Oriental Motor Product Forum Support
forum@orientalmotor.com


Return to “AC Motors”

Who is online

Users browsing this forum: No registered users and 1 guest